51 12... Replacing trim on rear bumper (M Technic aerodynamic kit)

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove rear bumper trim
Remove BOTTOM MIDDLE TRIM ON REAR BUMPER

Carefully heat trim (1) with hot air blower and detach with special tool 009317 from bumper (2).

Fig 1: Removing Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Minimum object temperature of trim and bumper ≥ 18°C.

If this temperature is not achieved, the components must be preheated.

For cleaning, use a fluff-free disposable cloth or a clean cleaning cloth.

Clean adhesive area of bumper with spirit.

Air drying time at least 1 minute.

Installation:

Trim (1) is positioned over guides (2) on bumper.

Remove liner from trim (1).

Press down trim (1) firmly with back of your hands over entire surface, especially the ends.

Fig 2: Identifying Bumper Guides And Trim

Courtesy of BMW OF NORTH AMERICA, INC.