51 45 380 Removing and installing (replacing) right decorative strip on dashboard
WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Risk of damage!
A hard disk is installed in the Car Information Computer (CIC).
Carry out mechanical work on the CIC and adjacent components with care.
Avoid subjecting the CIC to shaking/shocks.
IMPORTANT:
Risk of damage!
Do not turn special tool 00 9 317 when levering out and pay attention to pressure points.
Lever out decorative strip (2) from left side beginning at retaining points (1) with special tool 00 9 317.
Disconnect associated plug connection and remove decorative strip (2).
Do not turn special tool 00 9 317 when levering out and pay attention to pressure points.
Lever out decorative strip (2) from left side beginning at retaining points (1) with special tool 00 9 317.
Disconnect associated plug connection and remove decorative strip (2).
Installation:
Clips (1) must be seated in associated mountings.
If necessary, remove clips (1) remaining on decorative strip.
Replace damaged clips (1):
- Turn clip (1) with screwdriver to left by approx. 90°.
- Lever out clip (1) from below.
Replacement