51 71 407 Replacing rear spoiler (M)

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The INSTRUCTIONS on component cementing with double-sided adhesive tape serve as the basis for this repair instruction and must be observed without fail.

NOTE: To ensure correct bonding, it is essential to use the adhesive tape shaped parts developed for the respective rear spoiler.

Removing rear spoiler

Carefully detach rear spoiler (1) from rear lid with special tool 00 9 318 WEDGE (assembly wedge) and hot air blower.

Fig 1: Removing Rear Spoiler From Rear Lid Using Special Tool 00 9 318

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: To avoid paintwork damage, make sure markings (1) are only applied to adhesive tapes.

Carry over markings (1) from bottom to top of rear spoiler.

Fig 2: Identifying Markings On Rear Spoiler

Courtesy of BMW OF NORTH AMERICA, INC.

Aligning rear spoiler for installation:

Fig 3: Identifying Dimensions On Adhesive Tapes

Courtesy of BMW OF NORTH AMERICA, INC.

Determine center of rear lid.

Mark dimensions (A, B, C, D and E) on adhesive tapes (1) on left and right. Adhesive tapes must not be situated on bonding surface of rear spoiler.

ADHESIVE TAPE MODEL DESCRIPTION CHART

Model series	A	B	C	D	E
E90	250	200	330	332	334
E92	250	200	372	370	361
E82	250	200	371	372	376

Clean bonding surface on rear lid and rear spoiler with spirit.

NOTE: For cleaning, use a fluff-free disposable cloth or a clean cleaning cloth.
Air drying time at least 1 minute.

Fitting rear spoiler

IMPORTANT: Avoid the creation of bubbles and folds and do not overstretch when attaching the adhesive tape.

Pull off adhesive tape shaped part (1) from carrier film.

Position adhesive tape shaped part (1) starting from point (A) on front groove (2) and stick on.

Repeat same procedure on other side.

NOTE: Groove (2) serves as a limit marker.

Fig 4: Identifying Adhesive Tape Shaped Part And Groove

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: To enable the liner to be pulled off, cut only the adhesive tape and not the liner into lengths on the other side.
Fold back pull-off tabs of shaped parts and of adhesive tape towards rear. In so doing, make sure adhesive tape is not exposed.

Position adhesive tape (1) at distance (A) to adhesive tape shaped part (3) on front groove (2) and stick on.

A= 0.5... 2 mm

Fig 5: Identifying Distance For Positioning Adhesive Tape

Courtesy of BMW OF NORTH AMERICA, INC.

Align rear spoiler (1) using markings (2) and secure or press down slightly with a 2nd person helping.

Pull off liner using pull-off tabs (3).

Press down rear spoiler (1) firmly with thumbs or back of hands over entire surface, especially the ends.

Remove adhesive tapes, clean rear lid and rear spoiler.

Fig 6: Identifying Rear Spoiler With Markings

Courtesy of BMW OF NORTH AMERICA, INC.