61 31 229 Removing and installing/replacing both switches on sport steering wheel
WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks
- Remove AIRBAG UNIT
NOTE:
Illustrations show multifunction steering wheel (4) removed.
Release screws (1).
Detach decorative trim (3) in direction of arrow from holders (2).
Disconnect associated plug connection and remove complete decorative trim (3).
Installation:
Make sure electrical leads are correctly routed.
Feed wiring harness (4) out of associated holders.
Release screws (1) and remove both multifunction steering wheel switches (2) from decorative trim (3).
Installation:
Make sure there is a uniform gap between both multifunction steering wheel switches (2) and decorative trim (3).