61 14 010 Removing and installing/replacing distribution box (on battery)

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Observe SAFETY INSTRUCTIONS for handling vehicle battery.

Necessary preliminary tasks

Remove FLAP IN LUGGAGE COMPARTMENT PANEL on right
Disconnect BATTERY NEGATIVE LEAD

Release screws (1) and remove bracket (2). Tightening torque 61 14 1AZ .

Fig 1: Identifying Screws And Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Unlock plug housing (2) and release in direction of arrow.

Fold up covers on nuts (3).

Unscrew nuts (3). Tightening torque 61 21 2AZ .

Disconnect plug connection (4).

Disconnect plug connection of IBS cable (5).

Fig 2: Releasing Plug Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Press locking brackets (2) downwards and unclip.

If necessary, using a screwdriver (1), expand locking bracket (2) at lower end and clip out.

Remove power distributor (3) towards top.

Fig 3: Removing Power Distributor Towards Top

Courtesy of BMW OF NORTH AMERICA, INC.