84 10 050 Removing and installing (replacing) USB hub

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .

Necessary preliminary tasks

Remove LEFT FRONT SEAT
Remove FRONT LEFT ENTRANCE COVER STRIP
Fold back carpet for passenger compartment at front left in direction of travel

Remove USB hub protective socket (1) from footwell insert (2).

Unlock catches (3) with a suitable tool and remove USB hub protective socket cover (5).

Installation:

Make sure USB hub protective socket cover (5) engages correctly on USB hub protective socket lower section.

Seal (4) must not be damaged; if necessary, replace USB hub protective socket cover (5).

Fig 1: Identifying Seal And USB Hub Protective Socket Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Remove USB hub (1) from USB hub protective socket lower section (2).

Installation:

Make sure rubber grommet (4) is correctly seated on USB hub protective socket lower section (2).

Fig 2: Identifying USB Hub And USB Hub Protective Socket Lower Section

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (3).