33 33 101 Replacing two rubber mounts (rear) for rear axle carrier

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Lower REAR AXLE SUPPORT

If necessary, assemble special tool 33 4 140 DEVICE , 33 4 142 and 33 4 147 as shown.

If necessary, screw new thrust pieces 33 4 149 with countersunk screws on special tool 33 4 140 DEVICE .

Fig 1: Assembling Special Tools (33 4 140, 33 4 142 And 33 4 147)

Courtesy of BMW OF NORTH AMERICA, INC.

Coat top edge of rubber mount with Circo Light.

Fit special tool 33 4 441 on rubber mount in such a way that edge of rubber mount disappears in special tool.

Oil special tool 33 4 436 slightly before use.

Fig 2: Fitting Special Tool (33 4 441) On Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Align special tool 33 4 140 DEVICE by way of openings in rubber mount.

NOTE: Ensure it is correctly supported on bearing bushing of rear axle carrier.

Pull rubber mount with special tools 33 4 436, 33 4 437, 33 4 140 DEVICE and 33 4 431 out of bearing bush.

Installation:

Coat new rubber mount with Circo Light.

Insert special tool 33 4 444 in opening on rear axle carrier to avoid damaging the rear axle carrier when drawing in the rubber mount.

Oil special tool 33 4 434 slightly before use.

If necessary, assemble special tool 33 4 442, 33 4 443, 33 4 435 and 33 4 434 as shown.

Align rubber mount by way of arrow to direction of travel.

Draw in rubber mount as far as it will go.

Fig 3: Aligning Rubber Mount Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

After installation

Bleed BRAKING SYSTEM