8411519 Removing and installing or replacing eject box: Notes

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Pull off gaiter (1) towards top.

Disconnect plug connection (2).

Unclip plug connection for antenna lead from mounting and disconnect.

Fig 1: Disconnecting Plug Connection

G04728099

Courtesy of BMW OF NORTH AMERICA, INC.

Snap out eject box (1) with special tool 00 9 340 on inner side of trim (2).

Pull eject box (1) on inner side upwards slightly.

Fig 2: Removing Eject Box Using Special Tool (00 9 340)

G04728100

Courtesy of BMW OF NORTH AMERICA, INC.

Snap out eject box (1) with special tool 00 9 340 on outer side of trim (2).

Lift out eject box (1) and feed out wiring harness.

Installation:

Make sure wiring harness is correctly laid.

Eject box (1) must snap audibly into trim (2).

Fig 3: Removing Eject Box Using Special Tool (00 9 340)

G04728101

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) on trim (2) must not be damaged or missing.

Fig 4: Identifying Catches On Trim

G04728102

Courtesy of BMW OF NORTH AMERICA, INC.