Necessary preliminary tasks
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
- Remove FRONT BUMPER TRIM
- Remove HIGH-PRESSURE NOZZLE of headlight washer system
Release screw (1) on headlight arm (2) (from wheel arch side). Tightening torque 63 12 1AZ .
Release bolts (1). Tightening torque 63 12 3AZ .
M3:
Release screw (2). Tightening torque 63 12 7AZ .
Release wiring harness fastener (3) on headlight arm.
Remove high-pressure line and wiring harness from headlight arm.
Pull out headlight (4) slightly and disconnect associated plug connection.
Remove headlight (4) in direction of arrow.
Installation:
- Observe BODY GAP DIMENSIONS .
- Adjust HEADLIGHTS
Replacement up to 09/2008:
- Release screws (1) (tightening torque 63 12 2AZ ) and remove headlight arm (2) from headlight
- Remove ignition unit/bulb for xenon headlight See 6312871 REPLACING IGNITION UNIT FOR RIGHT XENON HEADLIGHT (WITH XENON BULB) or 6312870 REPLACING IGNITION UNIT FOR LEFT XENON HEADLIGHT (WITH XENON BULB)
- Remove control unit for xenon headlights See 6312860 REPLACING CONTROL UNIT FOR LEFT XENON HEADLIGHT or 6312861 REPLACING CONTROL UNIT FOR RIGHT XENON HEADLIGHT
- Remove drive/electronics box for adaptive headlight See 6312895 REPLACING DRIVE/ELECTRONICS BOX FOR LEFT ADAPTIVE HEADLIGHT (UP TO 09/2008) or 6312896 REPLACING DRIVE/ELECTRONICS BOX FOR RIGHT ADAPTIVE HEADLIGHT
- If necessary, remove bulbs:
Replacement as from 09/2008: