3714512 Replacing rear ride-height sensor

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

NOTE: Jointed rod to camber arm holder 37 14 3AZ .

Release nut (1) and disconnect jointed rod (2).

Installation:

Tightening torque 37 14 3AZ .

Disconnect plug connection (3).

Release bolt (4) and remove ride-height sensor with bracket.

Installation:

Align bracket to corresponding bore hole (arrow) in rear axle carrier.

Tightening torque 37 14 2AZ .

Fig 1: Identifying Jointed Rod, Bolt, Nut And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement

Release screws (1) and remove ride-height sensor from bracket (2).

Installation:

Sensor lever (3) must point from ride-height sensor in direction of screw fastening point (arrow) of bracket.

Tightening torque 37 14 1AZ .

Fig 2: Identifying Screws, Bracket And Sensor Lever

Courtesy of BMW OF NORTH AMERICA, INC.

After installation

Check HEADLIGHT ADJUSTMENT , correct if necessary