6620508 Removing and installing (replacing) control unit (Park Distance Control)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks:

Remove TRIM FROM REAR APRON
Remove RIGHT LUGGAGE COMPARTMENT TRIM PANEL
Partially detach insulating mat.

Release screws (1) and pull back device holder (2).

Fig 1: Pulling Back Device Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (1) and disconnect.

Unlock catch (2) in direction of arrow and remove control unit (3) upwards from device carrier (4).

Fig 2: Removing Control Unit Upwards From Device Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out PROGRAMMING/CODING .