2511111 Replacing shift rod joint: Installation

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335xi, and 2010 BMW 335i. However, it is still accessible from the selected car via links, so may be relevant.

Grease shift rod. See OPERATING FLUIDS .

Make sure shims (3) are in correct position.

IMPORTANT: New retaining clips fitted as from 04.08.
Retaining clip must interlock captively with retaining web (1) behind shift rod pin.

Fig 1: Identifying Retaining Web

Courtesy of BMW OF NORTH AMERICA, INC.

Lever spring washer (1) out of groove and push a little towards rear.

Press dowel pin (2) upwards/downwards out of shift rod joint and remove shift rod joint.

Grease ball of selector shaft. See OPERATING FLUIDS .

Replace spring washer (1).

Fig 1: Pressing Dowel Pinout Of Shift Rod Joint

Courtesy of BMW OF NORTH AMERICA, INC.

Check rubber ring (1) in shift rod joint (2) and replace if necessary.

Fig 1: Identifying Rubber Ring And Shift Rod Joint

Courtesy of BMW OF NORTH AMERICA, INC.