5226311 Removing and installing/replacing lock for left or right rear seat backrest (through-loading system)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Unlock rear seat backrest and fold down.

NOTE: In event of faulty unlocking, perform EMERGENCY OPENING .

Unclip Bowden cable from holders (1).

Unfasten screws (2).

Tightening torque 52 26 08AZ .

Fig 1: Identifying Bowden Cable And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Pull lock (1) out of installation opening slightly and unclip Bowden cable (2).

Remove lock completely from installation opening.

Installation:

Catches (2) on lock must not be damaged.

Bowden cable must be correctly anchored in catches (2).

Fig 2: Pulling Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slide guide lug (1) of lock into opening (2).

Fig 3: Sliding Guide Lug Of Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting lock:

Slacken screws
Firmly push engaged backrest back
Tighten down screws