LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2711 (Seats - Repair - E90) >> 5213 Front Seat, Normal, Manual >> 5213030 Removing and installing/replacing backrest frame on left or right front seat >> Necessary preliminary tasks

Necessary preliminary tasks

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Unclip cable (2).

Release airbag wiring harness (2) from cable holders on seat mechanism.

Cut through cable ties.

Raise release clip (3) and pull plug (4) out of plug housing (1).

Fig 1: Raising Release Clip
G04727011Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Always feed in cable tie (1) at narrow end of plug housing in direction of arrow.

Cables must be secured with insulation under cable tie.

Firmly tighten cable tie (1) to relieve strain. It must not be possible to move the cable.

Make sure plug (2) is correctly locked in plug housing (3).

Fig 2: Direction Of Feeding Cable Tie At Narrow End Of Plug Housing
G05779458Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Unclip cable.

Release wiring harness (3) from cable holders on seat mechanism.

Unfasten plug connection (2) and disconnect.

IMPORTANT: Feed all wiring harnesses carefully through the seat and backrest mechanism as the edges of the frame can be sharp.
Fig 3: Identifying Plug Connection And Wiring Harness
G04727012Courtesy of BMW OF NORTH AMERICA, INC.

E81, E82, E88, E92 only: 

Unhook seat covers on left and right.

Unclip ball socket (1) from ball head on left and right.

Installation: 

Ball socket (1) must snap audibly into place.

Ball socket (1) must be able to move freely on ball head.

Actuate rear catch and remove guide for Bowden cable (2) towards rear with a turning motion.

Fig 4: Identifying Ball Socket And Guide For Bowden Cable
G05779509Courtesy of BMW OF NORTH AMERICA, INC.

Unhook backrest cover (1) on left and right.

Release screws (2) on left and right.

Tightening torque 52 10 2AZ .

Remove backrest frame (3) completely towards top.

Fig 5: Removing Backrest Frame
G04727015Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: