Necessary preliminary tasks

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 328xi, 2010 BMW 328i, and 2009 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Remove FUEL PUMP

Unclip retaining clip (1) at top and bottom and slide out of holder (2).

Installation:

Retaining clip (1) is an integral part of the repair kit and must be fitted in each case.

Fig 1: Removing Holder

G06897868

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock fuel gauge sensor (1) in direction of arrow.

Slide fuel gauge sensor in direction of arrow out of holder (2).

Fig 2: Sliding Fuel Gauge Sensor

G06897869

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Position retaining clip (1) with longer guide pin (2) in holder at top (3).

Position shorter guide pin (4) in holder at bottom (5).

Slide in retaining clip (1).

Ensure retaining clip is correctly engaged.

Fig 3: Identifying Guide Pins With Retaining Clips

G06897870

Courtesy of BMW OF NORTH AMERICA, INC.