Necessary preliminary tasks

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Remove GLASS SLIDE/TILT SUNROOF LID

NOTE: If activating the function when removed:

It is essential to ensure that the slide of rain gutter (1) is situated ahead of connecting element (2).
If the slide of rain gutter (1) is situated below the connecting element, this will result in a collision and damage.

Fig 1: Identifying Rain Gutter And Connecting Element
Courtesy of BMW OF NORTH AMERICA, INC.

Lever connecting element (2) on left and right out of rain gutter linkage (1).

Installation:

Linkage must be felt to snap into place in connecting element.

Fig 2: Removing Connecting Element Out Of Rain Gutter Linkage

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip linkage of rain gutter (1) on left and right out of connecting element slide (2) towards rear.

Fig 3: Identifying Rain Gutter And Connecting Element Slide

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Carry out function check only with rain gutter fitted (risk of damage).