2450030 Replacing selector shaft (GA6L45R)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 328xi, 2010 BMW 328i, and 2010 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: After completion of work, CHECK TRANSMISSION OIL LEVEL .

Use only the approved transmission fluid: Dexron VI automatic transmission fluid ; BMW part number 83 22 0 397 114 (4 liters)

Failure to comply with this requirement will result in serious damage to the automatic transmission!

Necessary preliminary tasks:

REMOVE MECHATRONICS
Remove SELECTOR SHAFT SEAL
Remove transmission (AWD only)

Drive a metal pin (1) - dia. approx. 3 mm - into clamping pin (2) (to prevent clamping pin from being compressed).

Grip clamping pin (2) with side nippers.

NOTE: Illustration similar

Fig 1: Driving In Metal Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Drive clamping pin (2) with a suitable tool out of selector shaft.

Remove selector shaft.

Fig 2: Driving Clamping Pin

Courtesy of BMW OF NORTH AMERICA, INC.