24 40 011 Removing and installing/replacing torque converter (GA6HP19Z)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 328xi, 2010 BMW 328i, and 2010 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

After completion of repair work, check TRANSMISSION OIL LEVEL .

Use only the approved transmission fluid: Shell M-1375.4 ; BMW part number 83 22 0 142 516 (20 liters)

Failure to comply with this instruction will result in serious damage to the transmission.

Necessary preliminary tasks:

Remove automatic transmission

Screw special tool 24 4 000 into torque converter.

Remove torque converter.

NOTE: When torque converter is removed, transmission oil flows out.

Fig 1: Identifying Special Tool (24 4 000)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

When installing, do not damage shaft seal and bearing.

If the torque converter is not correctly installed, the driver of the pump impeller may be damaged when the transmission is flanged to the engine.

Remove torque converter and set down vertically.

Fig 2: Removing Torque Converter And Set Down Vertically

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Push torque converter through shaft seal onto transmission shaft as far as it will go.

Press torque converter by hand into converter housing and turn in the process. Converter hub recess must snap into place in driver of pump impeller. Torque converter must be felt to slip inwards.