2400050 Installing exchange transmission (GA6L45R)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 328xi, 2010 BMW 328i, and 2010 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.
Drain automatic transmission fluid at oil drain plug.
Tightening torque: 24 11 6AZ .
Recycling:
Catch and dispose of escaping transmission fluid.
Observe country-specific waste-disposal regulations
IMPORTANT:
- Before installing replacement transmission, always flush TRANSMISSION FLUID COOLER TOGETHER WITH LINES .
- After completion of work, check TRANSMISSION OIL LEVEL .
Replacement transmission is supplied filled with transmission fluid.
Use only the approved transmission fluid: Dexron VI automatic transmission fluid ; BMW part number 83 22 0 397 114 (4 liters)
Failure to comply with this instruction will result in serious damage to the transmission.
Necessary preliminary tasks:
- Remove transfer case (AWD)
- Remove automatic transmission
Remove transportation lock (1).
Convert all cable holders.
Convert all seal plugs.
Remove protective cap on output shaft.
If necessary, modify transmission support block.
Tightening torque 24 71 6AZ .
IMPORTANT:
After removing transportation lock, secure torque converter against slipping out.
Transmission identification:
- refer to BMW Parts Department.
- On type plate