24 00 050 Installing exchange transmission (GA6HP19Z)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 328xi, 2010 BMW 328i, and 2010 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.
Drain automatic transmission fluid at oil drain plug.
Tightening torque: 24 11 6AZ .
IMPORTANT:
After completion of work, program transmission control unit.
Recycling:
Catch and dispose of escaping transmission fluid.
Observe country-specific waste-disposal regulations
IMPORTANT:
- Before installing exchange transmission, always flush TRANSMISSION FLUID COOLER TOGETHER WITH LINES .
- After completion of work, check TRANSMISSION OIL LEVEL .
Exchange transmission is supplied filled with transmission oil.
Use only the approved transmission fluid: Shell M-1375.4 ; BMW part number 83 22 0 142 516 (20 liters)
Failure to comply with this instruction will result in serious damage to the transmission.
Necessary preliminary tasks:
- Remove automatic transmission
If necessary:
Release screws.
Remove and convert transmission bearing block (1).
Tightening torque 24 71 6AZ .
Convert transportation retainer (1).
Convert all cable clips.
Convert all seal plugs.
Remove protective cap on output shaft.
IMPORTANT:
After removing transportation retainer, secure torque converter against slipping out.
Transmission identification:
- refer to BMW Parts Department.
- On type plate