1810031 Replacing rear muffler (N51): Notes
WARNING: This page is about a different car, the 2011 BMW 328i, 2010 BMW 328i, and 2009 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Scalding hazard!
Only perform these tasks on an engine that has cooled down.
Only perform these tasks on an engine that has cooled down.
Support rear muffler with special tool 31 2 220 .
NOTE:
If the cutting line is not marked by a punch mark in the pipe, determine the cutting line by means of the pipe length on the new rear muffler (4).
Carry over cutting line to faulty rear muffler (4) and mark out.
Carry over cutting line to faulty rear muffler (4) and mark out.
Cut exhaust pipe at marked point with special tool 00 2 210 and deburr.
Unfasten nut.
Tightening torque 18 20 4AZ .
Release screw on right bracket.
Tightening torque 18 20 5AZ .
Installation:
Connect front muffler to rear muffler by means of clamp and align.
Centre clamp and tighten down.
Tightening torque 18 20 8AZ .
NOTE:
Check exhaust system for leaks.