5171447 Removing and installing/replacing trim for cover on left or right side member (from 09/08)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Release screws (1).

Remove trim from front beginning at side.

Lever off catch on rear wheel arch cover and remove side sill.

Fig 1: Identifying Side Sill Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure spacers (1) are correctly positioned between underbody trim and bodyshell.

Fig 2: Identifying Spacers

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, remove retaining strips (1) from bodyshell

Clip retaining strips (1) into sill cover (2).

Clip sill cover (2) into bodyshell.

Listen out for audible clicking noises.

Visual check:

Make sure sill cover (2) is correctly seated and observe wheel arch BODY GAP DIMENSIONS . at front and rear.

Fig 3: Identifying Clip Retaining Strips And Cover

Courtesy of BMW OF NORTH AMERICA, INC.