5145380 Removing and installing (replacing) right decorative strip on dashboard: Notes

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Risk of damage!

A hard disk is installed in the Car Information Computer (CIC).

Carry out mechanical work on the CIC and adjacent components with care.

Avoid subjecting the CIC to shaking/shocks.

IMPORTANT: Risk of damage!
Do not turn special tool 00 9 317 when levering out and pay attention to pressure points.

Lever out decorative strip (2) from left side beginning at retaining points (1) with special tool 00 9 317 .

Disconnect associated plug connection and remove decorative strip (2).

Fig 1: Levering Out Decorative Strip From Left Side Beginning Using Special Tool (00 9 317)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clips (1) must be seated in associated mountings.

If necessary, remove clips (1) remaining on decorative strip.

Replace damaged clips (1):

Turn clip (1) with screwdriver to left by approx. 90°.
Lever out clip (1) from below.

Fig 2: Removing Clips
Courtesy of BMW OF NORTH AMERICA, INC.