Necessary preliminary tasks

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Remove GUTTER STRIP

NOTE: To facilitate installation, coat seal and gutter strip with water.

Fit inner part (1) of seal in accordance with measurements (A and B) on gutter strip (2).

A= approx. 30 mm

B= approx. 15 mm

Push seal (1) onto gutter strip (2) until both are flush in area (3).

Fig 1: Identifying Seal Onto Gutter Strip

G06202669

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Outer part (2) and inner part (3) of seal must not be stretched.

Fit outer part (2) and inner part (3) of seal on complete gutter strip (1).

If necessary, use special tool 00 9 323 as an aid.

Fig 2: Identifying Outer Part And Inner Part Of Seal On Gutter Strip

G06202670

Courtesy of BMW OF NORTH AMERICA, INC.

Align seal (1) to gutter strip (2) and secure in area (3) with Loctite 380 (sourcing reference: BMW Parts Service).

A= Gutter strip, top

B= Gutter strip, bottom

Fig 3: Identifying Seal To Gutter Strip In Area

G06202671

Courtesy of BMW OF NORTH AMERICA, INC.