Replacement of rubber frame without windscreen removal
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
There is no sealing lip (2) in area (A) on left/right.
Detach tear-off lip (4) from rubber frame (1).
If adhesive leaks over tear-off lip (4), this area must be cut out partially.
To facilitate installation, coat rubber frame (1) and body cutout with water.
Install rubber frame (1).
If necessary, pull liner* off adhesive tape (6) and press rubber frame (1) down firmly on roof outer skin.
- 3 Butylene tape
- 5 Aluminium strip
* Liner is the protective film on adhesive tape (6).