Necessary preliminary tasks

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Remove FOOTWELL SIDE TRIM PANEL
Remove LOWER SECTION OF MICROFILTER HOUSING ON LEFT

Disengage Bowden cable (1) from release lever (2) and feed out in direction of arrow.

Fig 1: Disengaging Bowden Cable From Release Lever

G04752663

Courtesy of BMW OF NORTH AMERICA, INC.

Release expander rivet (1) and nut (2).

Feed out water channel (3) towards top.

Installation:

Make sure water channel (3) is correctly seated.

Fig 2: Identifying Expander Rivet And Nut

G04752664

Courtesy of BMW OF NORTH AMERICA, INC.

Feed out Bowden cable (1) in direction of engine compartment.

Installation:

Lay Bowden cable (1) without kinks.

IMPORTANT: Grommet (2) must not be damaged.
Check that grommet (2) is correctly seated (water ingress).

Fig 3: Identifying Bowden Cable And Grommet

G04752665

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip coupling (1) from side panel.

Lever out cover (2) at coupling (1).

Lever Bowden cable (3) out of coupling (1) and remove.

Fig 4: Identifying Coupling, Cover And Bowden Cable

G04752650

Courtesy of BMW OF NORTH AMERICA, INC.