LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2701 (Body Equipment - Repair - E90) >> 5116 Mirrors/Covers/Ashtrays/Shelves/Trays >> 5116060 Removing and installing/replacing interior rearview mirror (with mirror arm end caps) >> Notes

5116060 Removing and installing/replacing interior rearview mirror (with mirror arm end caps): Notes

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Work may only be carried out at a room/object temperature of 18... 28 ° C.
If this cannot be guaranteed (cold/hot countries), it is necessary to equalize the temperature of the windscreen, mirror foot and rearview mirror (e.g. car left to stand indoors or in the shade for at least 30 minutes).

Version with remote control for central locking: 

If necessary, disconnect negative lead from BATTERY .

Version with compass: 

Check compass function if replacing or after disconnecting interior mirror plug connection or battery.

If necessary, CALIBRATE COMPASS IN INTERIOR REARVIEW MIRROR .

IMPORTANT: To avoid breaking windscreen: 
Snap out (press) rearview mirror only in direction of travel towards windscreen.
Do not under any circumstances twist the mirror foot when removing.
Twisting the mirror off the mirror mount will damage the rear catch.
If the rear catch is damaged, the mirror will be loose when installed and must be replaced.
NOTE: Do not exert any pressure on mirror foot when removing end caps (1).

Press end caps (1) towards mirror housing (2); this releases clip connection of both caps (1).

In order not to create any tension at the mirror foot, simultaneously apply counter-pressure to the mirror housing when removing the end caps.

Fig 1: Pressing End Caps
G04749642Courtesy of BMW OF NORTH AMERICA, INC.

Twist mirror (1) at an angle towards front and right/top.

Swivel left end cap (2) off ball neck in direction of arrow; this detaches the engagement clip (3) from the metal foot.

Fig 2: Removing Left End Cap
G04749643Courtesy of BMW OF NORTH AMERICA, INC.

Twist mirror (1) at an angle towards front and left/top.

Swivel right end cap (2) off ball neck in direction of arrow; this detaches the engagement clip from the metal foot.

Fig 3: Removing Right End Cap
G04749644Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Clips (1) and retaining hooks (2) of end caps (3) must not be damaged, replace if necessary.

Fig 4: Identifying Clips, Retaining Hooks And End Caps
G04749645Courtesy of BMW OF NORTH AMERICA, INC.

Version with cable (X): 

Disconnect plug connection (1).

Fig 5: Identifying Plug Connection
G04749646Courtesy of BMW OF NORTH AMERICA, INC.
IMPORTANT: Risk of damage!
Do not pull off rearview mirror (1) from windscreen against direction of travel and or snap out by turning.

Snap out interior mirror (1) from mirror mount (2) towards front with increasing pressure (not abruptly) and remove.

Fig 6: Removing Interior Mirror From Mirror Mount
G04749647Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

  1. Twist mirror foot by approx. 45° and fit to mirror mount.
  2. Turn mirror foot until it engages on mirror base.
    Fig 7: Turning Mirror Foot
    G04749641Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals