5116060 Removing and installing/replacing interior rearview mirror (with Autobeam): Notes

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Work may only be carried out at a room/object temperature of 18... 28 ° C.
If this cannot be guaranteed (cold/hot countries), it is necessary to equalize the temperature of the windscreen, mirror foot and rearview mirror (e.g. car left to stand indoors or in the shade for at least 30 minutes).

Version with remote control for central locking:

If necessary, disconnect negative lead from BATTERY .

IMPORTANT: To avoid breaking windscreen:
Snap out (press) rearview mirror only in direction of travel towards windscreen.
Do not under any circumstances twist the mirror foot when removing.
Twisting the mirror off the mirror mount will damage the rear catch.
If the rear catch is damaged, the mirror will be loose when installed and must be replaced.

Press on end caps (1) and at same time pull them apart; this releases clip connection of both caps (1).

Twist mirror (2) and detach end caps (1) from mirror and feed out.

Fig 1: Removing Mirror

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retaining hooks (1 and 2) of end caps (3) must not be damaged.

Fig 2: Identifying Hooks Of End Caps

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connections (1 and 2).

Installation:

If necessary, pay attention to cable routing for rain sensor.

Fig 3: Identifying Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!
Do not pull off rearview mirror (1) from windscreen against direction of travel and or snap out by turning.
When snapping out, avoid damaging rain sensor (3).

Carefully press mirror (1) forwards out of mirror base (2).

If mirror (1) rests on rain sensor (3), snap mirror (1) out in inward direction.

Fig 4: Removing Mirror

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Twist mirror foot by approx. 45° and fit to mirror mount.
Turn mirror foot until it can be felt to engage on mirror base.
Visually inspect for positive locking.

Fig 5: Turning Mirror Foot
Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Normalization or initialization is not necessary.

Autobeam is automatically aligned under the following conditions:

Driving on a motorway/ordinary road at night for approx. 50 km and
Clearly visible road markings