LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2701 (Body Equipment - Repair - E90) >> 5114 BMW Emblems, Model Emblems >> 5114110 Removing and installing/replacing rear model designation >> M3 only

M3 only

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Attach adhesive tape (1) between edge of rear lid (2) and measurement "A".

Mark out measurement "B" at top edge of adhesive tape (1) to outer edge of rear lid.

E90: 

A = 21 mm

B = 147 mm

E92/E93: 

A = 21 mm

B = 139 mm

NOTE: Measurement "C" is for information purposes only, as it is determined by carrier film.

C = 5.9 mm

Fig 1: Identifying Rear Model Designation Fitting Dimensions (E90)
G06180272Courtesy of BMW OF NORTH AMERICA, INC.