5114110 Removing and installing/replacing rear model designation (Brilliance)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The "INSTRUCTIONS FOR NUMBER/LETTER COMBINATION CEMENTING " serve as the basis for these repair instructions and must be followed without fail.

Attach adhesive tape (1) between edge of rear lid (3) and top edge measurement "A".

Mark measurement "B" from outer edge of rear lid on adhesive tape (1) and stick on adhesive tape (2) vertically.

Measurements E60:

A = 18 mm

B = 38 mm

Measurements E90:

A = 25 mm

B = 46 mm

Fig 1: Identifying Rear Model Designation Measurements

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off liner (protective strip for adhesive surface).

Position characters on adhesive tapes (1 and 2) and stick into place.