Necessary preliminary tasks

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Version with headlight washer system:

Remove COVER FOR HEADLIGHT WASHER SYSTEM on left/right

Release screws (1) on bumper trim (2).

Fig 1: Identifying Screws On Bumper Trim

G04752443

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The operation is described on the left side; proceed in the same way for the right side.

Release screws (1) on wheel arch trim (2).

Lift out wheel arch trim (2) at side.

Installation:

Make sure wheel arch trim (2) is in correct position.

Fig 2: Identifying Screws On Wheel Arch Trim

G06202352

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The operation is described on the left side; proceed in the same way for the right side.

Press wheel arch cover (1) to one side.

Release screws (2).

Fig 3: Identifying Wheel Arch Cover With Screws

G04752445

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on bumper trim (2).

Fig 4: Identifying Screws On Bumper Trim

G05779010

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Do not damage bumper trim when pulling off.

Detach bumper trim (1) at sides.

Pull bumper trim (1) forwards slightly and if necessary disconnect plug connections on ultrasonic sensors and/or fog lights.

Remove bumper trim (1) towards front with aid of a 2nd person.

Installation:

Height adjustment, refer to BODY GAP DIMENSIONS .

Fig 5: Removing Bumper Trim

G04752447

Courtesy of BMW OF NORTH AMERICA, INC.