4. Bonding
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
4.1 Components without pre-fitted adhesive tape
- Pull off liner* from adhesive tape
- Position adhesive tape on component and stick on
- Press down adhesive tape over entire adhesive area
- Continue with Point 4.2
* Liner is the protective film on the adhesive tape
4.2 Components with pre-fitted adhesive tape
- Pull off liner* from adhesive side (if adhesive area is large, do not pull off liner completely)
- Align component in correct position on vehicle
- Press down component over entire adhesive area
* Liner is the protective film on the adhesive tape