3610508 Stationary wheel balancing

Necessary preliminary tasks 

• Remove WHEEL 

Remove any fitted balancing weights, stones in tread pattern and larger contaminants.

Check tire pressure, check tire for condition, damage, flat spots (out-of-round caused by e.g. stopping the car with hot tires); if necessary, check wheel and tire for RADIAL AND LATERAL RUNOUT  .

Fig 1: Identifying Wheel On Balancing Machine

Courtesy of BMW OF NORTH AMERICA, INC.

Use BMW-approved centering elements of relevant balancing machine manufacturers.

1. Basic flange
2. Wheel centering element
3. Type flange
4. Clamping nut

Fig 2: Identifying Basic Flange, Wheel Centering Element, Type Flange And Clamping Nut

Courtesy of BMW OF NORTH AMERICA, INC.

On light-alloy rims with distinctive J-shape rim flange, proceed as follows:

1. Gently press off tire sidewall with special tool 36 1 020 PLIERS at appropriate point from rim flange.
2. Install retaining clip (1).
3. Remove special tool 36 1 020 PLIERS .
   Fig 3: Pressing Off Tyre Sidewall With Special Tool (36 1 020)

   Courtesy of BMW OF NORTH AMERICA, INC.

Raise retaining clip with special tool 36 1 010 LEVER . Slide balance weight underneath and allow it to snap into place.

Fig 4: Raising Retaining Clip Using Special Tool (36 1 010)

Courtesy of BMW OF NORTH AMERICA, INC.

Arrangement of balance weights for light-alloy rims with distinctive J-shape rim flanges.

1. Spring retainer
2. Balance weight

Adhesive weights must be used on all other light-alloy rims.

Max. imbalance per wheel  See WHEELS TWO-PART ALLOY WHEELS ; WHEELS ONE-PART ALLOY WHEELS or WHEELS STEEL AND ALUMINUM STRIP WHEELS .

Fig 5: Identifying Spring Retainer And Weight Balance

Courtesy of BMW OF NORTH AMERICA, INC.