3452550 Removing and installing/replacing DSC sensor

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335xi, and 2010 BMW 335i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks

Remove LEFT FRONT SEAT
Remove FRONT LEFT ENTRANCE COVER STRIP

Lift carpet (1) and fold back to side.

Remove underlay (2).

Disconnect plug connection.

Installation:

Ensure proper locking of plug connector.

Slacken screws (3)

Release screws (4) and remove bracket with yaw sensor.

Installation:

Tightening torque 34 51 3AZ, see 34 51 SLIP CONTROL SYSTEM (DSC) . .

Fig 1: Identifying Carpet, Underlay And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

When replacing DSC sensor:

Release screws (1) and modify DSC sensor (2).

Installation:

Tightening torque 34 51 2AZ, see 34 51 SLIP CONTROL SYSTEM (DSC) . .

Fig 2: Identifying DSC Sensor And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Carry out calibration/adjustment of DSC sensor.