3400513 Checking parking brake setting (vehicle check for service)

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335xi, and 2010 BMW 335i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Follow instructions for BRAKE TESTING ON TEST STAND .

NOTE: If deviations are identified during the following check, the parking brake must be adjusted:

0th tooth (handbrake released): Vehicles with manual transmission: Shift lever in neutral position.

Vehicles with automatic transmission: Selector lever in "N" position.

Without locking differential ≤ 150 N.
With locking differential ≤ 200 N (possibly odd display).

1st tooth: No increase in braking force with regard to 0th tooth. Indicator lamp can be lit.

2nd tooth: Indicator lamp must be lit.

3rd tooth: Increase in braking force.

5th tooth: The brake force display must have reached ≥ 400 N.

Checking brake force differential at wheel:

Apply handbrake until a wheel circumferential force (measured on brake test stand) of min. 1000 N is reached.

Max. permitted brake force differential right/left ≤ 35 % (referred to greater brake value).

It must be possible to brake with locked wheels with the handbrake.