3432861 Replacing all brake pipes
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335xi, and 2010 BMW 335i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The brake lines are only supplied in the straight version and correct length with connecting nipple.
Read and comply with GENERAL INFORMATION .
After completing work, BLEED BRAKE SYSTEM .
OBSERVE SAFETY INSTRUCTIONS ON RAISING THE VEHICLE .
Read and comply with GENERAL INFORMATION .
After completing work, BLEED BRAKE SYSTEM .
OBSERVE SAFETY INSTRUCTIONS ON RAISING THE VEHICLE .
The new brake lines are bent into shape with bending tool 34 5 100 .
Removed brake pipes can be used as templates for bending.
IMPORTANT:
- Protective coating of brake line must not be damaged during bending.
- Do not kink or bend back brake lines.
- Watch distances to rigid and movable vehicle parts. Brake lines may not make contact or rub.
- Tighten down brake line couplings with torque wrench.
Installation:
Tightening torque 34 32 1AZ .