LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2692 (General Electrical System - Repair - E90) >> 6171 Window Washer System >> 6171061 Replacing washer fluid reservoir for windscreen washer system >> Necessary preliminary work

Necessary preliminary work

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335xi, and 2010 BMW 335i. However, it is still accessible from the selected car via links, so may be relevant.

Clip cable (1) out of mounting.

Clip hose (5) out of mounting.

Unlock filler hose (2) and detach from fitting on fluid reservoir (3).

NOTE: Catch any escaping washer fluid if necessary.

Unscrew bolts (4) and (6).

Pull fluid reservoir (3) forwards slightly.

Fig 1: Pulling Fluid Reservoir
G04727684Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Retaining lug (2) of fluid reservoir (1) must be correctly seated in clip (3).

Fig 2: Identifying Retaining Lug Of Fluid Reservoir And Clip
G04727685Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect all plug connections.

Remove level switch (1) .

Remove WINDSCREEN WASHER PUMP (3) .

If necessary, remove washer pump for rear window washer system (2).

If necessary, remove WASHER PUMP FOR HEADLIGHT WASHER SYSTEM (4) .

Remove washer reservoir.

Fig 3: Identifying Window Washer System And Windscreen Washer Pump
G04727686Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: