Necessary preliminary tasks

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335xi, and 2010 BMW 335i. However, it is still accessible from the selected car via links, so may be relevant.

Remove COVER FROM SPRAY NOZZLE
Remove FRONT WHEEL ARCH COVER

To prevent excessive escape of washer fluid, seal off end of high-pressure line with special tool 13 3 010 .

Catch any escaping washer fluid if necessary.

Fig 1: Sealing High Pressure Line End Using Special Tool (13 3 010)

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Bumper trim shown removed for purposes of clarity.

Unlock catch (1) in direction of arrow.

Feed high-pressure nozzle (2) towards rear out of headlight arm (3).

Unlock plug connection on high-pressure nozzle (2) and detach high-pressure line from high-pressure nozzle (2).

Fig 2: Removing Catch

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Keep plug connection for high-pressure nozzle and high-pressure line clean and free from grease.

Ensure guide (2) is correctly seated.

Retaining lugs (1) must snap audibly into place.

Check function.

If necessary, adjustment can be carried out carefully using pointed pliers (tape of front area with adhesive tape where necessary).

If necessary, top up washer fluid.

Fig 3: Identifying Guide And Retaining Lugs

Courtesy of BMW OF NORTH AMERICA, INC.