Necessary preliminary tasks

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335xi, and 2010 BMW 335i. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect BATTERY NEGATIVE LEAD
Remove FOOTWELL SIDE TRIM PANEL on A-pillar, right
Remove TRIM FOR INSTRUMENT PANEL , bottom right

NOTE: Glovebox removed for purposes of clarity.

Disconnect plug connection (1).

Release screws (2) and remove junction box electronics (3) from holder.

Fig 1: Identifying Junction Box Electronics With Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Installation:

Make sure junction box electronics is correctly seated on plug connection (2) of holder.

Fig 2: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out VEHICLE PROGRAMMING/CODING .

Delete transport mode.