Necessary preliminary tasks

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335xi, and 2010 BMW 335i. However, it is still accessible from the selected car via links, so may be relevant.

Remove TRIM PANEL FOR PEDAL ASSEMBLY .

Unfasten plug connection (1) and disconnect.

Pull brake light switch (2) in direction of arrow out of brake light switch holder (3).

Installation:

Press brake pedal (4) to floor.
Slide brake light switch (2) as far as it will go into brake light switch holder (3).
Grip brake light switch holder (3), slowly return brake pedal (4) to starting position and pull back to stop .

Fig 1: Pulling Brake Light Switch Out Of Brake Light Switch Holder
Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Removing brake light switch holder (2):
Press brake pedal.
Press catches (1) together and unclip brake light switch holder (2) from bearing block (3).

Fig 2: Removing Brake Light Switch Holder

Courtesy of BMW OF NORTH AMERICA, INC.