51 61 Reinforcement, body
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - REINFORCEMENT, BODY
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Tension strut in engine compartment | E60/E61/E63/E64 | M8 | Replace screws Screw connection again New component/initial screw connection |
27 Nm 30.5 Nm |
| 2AZ Structural tension strut, front | E64 | M12 | Replace screws Jointing torque Torque angle |
100 Nm 90 ° |
| E64 | M6 | Replace screws Jointing torque | 8 Nm | |
| 3AZ Tension strut to rear axle | E60/M5, E61/M5, E63/M6, E64/M6 | M8 | M8 8.8 M8 10.9 |
24 Nm 30 Nm |
| E61, E64 | M12 | Replace screws Jointing torque Torque angle |
100 Nm 90 ° |
|
| E61, E64 | M8 | Nut | 19 Nm | |
| 4AZ Tension strut, rear axle, front | E61/M5, E64/M6 | M12 | Replace screws Jointing torque Torque angle |
100 Nm 90 ° |
| 5AZ Tension strut, rear axle, rear | E61/M5, E64/M6 | M12 | Replace screws Jointing torque Torque angle |
100 Nm 90 ° |
| 6AZ Cross strut/rear | E61, E64 | M10 | Nuts Screws |
41 Nm 59 Nm |
| 7AZ Connecting carrier to body (tunnel) | E60, E61, E63, E64, E87, E88, E90, E91, E92/S65, E93 | M8 | 24 Nm | |
| E65, E66 | M8 | 19 Nm | ||
| E83 | M8 | 23 Nm |