3333101 Replacing two rubber mounts (front) for rear axle carrier

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335i, 2010 BMW 328i, and 2010 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Lower rear axle support See 3331503 LOWERING/RAISING REAR AXLE CARRIER (SPECIAL TOOL SWZ00-2040) or 3331503 LOWERING/RAISING REAR AXLE CARRIER (UNIVERSAL LIFTER)

If necessary assemble special tools 33 4 140 DEVICE , 33 4 142 and 33 4 147 as illustrated.

If necessary screw new synchronizing keys 33 4 149 onto special tool 33 4 140 DEVICE with countersunk screws

Fig 1: Assembling Special Tools 33 4 140, 33 4 142 And 33 4 147

Courtesy of BMW OF NORTH AMERICA, INC.

Coat top edge of rubber mount with Circo Light (refer to BMW Parts Service).

Fit special tool 33 4 431 on rubber mount in such a way that edge of rubber mount disappears in special tool.

Oil special tool 33 4 436 lightly before use.

Align special tool 33 4 140 DEVICE by way of openings in rubber mount.

NOTE: Ensure it is correctly supported on bearing bushing of rear axle carrier.

Fig 2: Removing Rubber Mount Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

Using the special tools 33 4 436, 33 4 437, 33 4 140 DEVICE and 33 4 431, pull rubber mount out of bearing bush.

Installation:

Coat new rubber mount with Circo Light (refer to BMW Parts Service).

Oil special tool 33 4 434 lightly before use.

If necessary, assemble 33 4 432, 33 4 433, 33 4 435 and 33 4 434 as illustrated.

Align rubber mount by way of arrow to direction of travel.

Draw in rubber mount as far as it will go.

Fig 3: Assembling 33 4 432, 33 4 433, 33 4 435 And 33 4 434

Courtesy of BMW OF NORTH AMERICA, INC.

After installation

Bleed BRAKING SYSTEM