3332195 Replacing rubber mount for camber arm in rear axle support

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335i, 2010 BMW 328i, and 2010 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Risk of burns!
This work may only be carried out on an exhaust system which has cooled down.

Necessary preliminary tasks

Remove COIL SPRING
Remove CAMBER ARM FROM REAR AXLE SUPPORT

Removing rubber mount

Pull out and remove rubber mount with special tools 33 4 462, 33 4 464, 33 4 463, 33 4 466 and 33 4 465.

Fig 1: Removing Rubber Mount Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

Installing new rubber mount

Pull together rubber mount with special tools 33 4 455, 33 4 456, 33 4 452 and 33 4 451.

Fig 2: Installing Rubber Mount Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

Draw rubber mount into rear axle support so that slot (1), rubber mount center point and notch (2) form a line.

Fig 3: Identifying Slot And Notch

Courtesy of BMW OF NORTH AMERICA, INC.

Draw rubber mount into rear axle support as far as possible using special tools 33 4 461, 33 4 463, 33 4 466 and 33 4 465.

Remove special tool and draw in rubber mount as far as it will go.

Fig 4: Installing Rubber Mount Into Rear Axle Support Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

After installation

Perform wheel/chassis alignment check See 3200150 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION or 3200155 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH RIDE HEIGHT MEASUREMENT WITHOUT VEHICLE LOAD