3332180 Removing and installing/replacing left or right toe arm

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335i, 2010 BMW 328i, and 2010 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If the toe arm is detached from the rear axle support/wheel carrier, it is necessary after reinstallation to carry out a wheel/chassis alignment check.

Necessary preliminary tasks

Remove REAR WHEEL

If necessary, open cover (1) on stoneguard (2).

Mark position of eccentric bolt to rear axle support.

Fig 1: Identifying Cover And Stoneguard

G05778394

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolt.

Tightening torque 33 32 8AZ .

Installation:

If necessary, turn toe arm by hand.

Fig 2: Locating Toe Arm Bolt

G04726512

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1) and remove eccentric washer (2).

Tightening torque 33 32 7AZ .

Unscrew eccentric bolt towards front and remove toe arm (3).

Installation:

Bolt head points in direction of travel.

Reinstall eccentric washer.

Replace self-locking nut.

Align eccentric bolt to rear axle support by means of marking.

Fig 3: Removing Toe Arm

G04726513

Courtesy of BMW OF NORTH AMERICA, INC.

After installation

Perform wheel/chassis alignment check See 3200150 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION or 3200155 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH RIDE HEIGHT MEASUREMENT WITHOUT VEHICLE LOAD