3332091 Replacing a control arm
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335i, 2010 BMW 328i, and 2010 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If the control arm is detached from the rear axle support, it is necessary after reinstallation to carry out a wheel/chassis alignment check.
Necessary preliminary tasks
- Remove REAR WHEEL
Release screw.
Tightening torque 33 32 4AZ .
Installation note:
If necessary, raise wheel carrier in area of brake caliper by hand.
Replace screw.
IMPORTANT:
Make sure during installation that in the connection area to the wheel carrier the tapered end of the bearing bushing (of the rubber mount) points in the direction of the wheel carrier.
NOTE:
On the M3 a ball joint is fitted in the guide arm.
Slacken nut (1).
Tightening torque 33 32 3AZ .
Unscrew bolt towards rear and remove guide arm (2).
Installation note:
Bolt head must point to rear.
Replace self-locking nut.
After installation
- Perform chassis/wheel alignment check See 3200150 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION or 3200155 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH RIDE HEIGHT MEASUREMENT WITHOUT VEHICLE LOAD