Necessary preliminary tasks

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335xi, and 2010 BMW 335i. However, it is still accessible from the selected car via links, so may be relevant.

Drain gear oil at oil drain plug.
Tightening torque: 23 00 4AZ
REMOVE TRANSMISSION

Convert shift rod joint.

Push back retaining ring (1) and drive out dowel pin (2).

Fig 1: Removing Dowel Pin

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check damping disc (6) for damage and replace if necessary.

Fig 2: Identifying Damping Disk

Courtesy of BMW OF NORTH AMERICA, INC.

Convert following parts from previous transmission to new transmission.

RELEASE BEARING AND RELEASE LEVER
Ball pin and spring wire clip
Studs for clutch slave cylinder
Reversing light switch, tightening torque: 23 11 1AZ .

Reassemble the vehicle.

Check oil level.

Installation:

Observe GREASING SPECIFICATION