13 11 Carburetor
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 328xi, 2010 BMW 328i, and 2009 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - CARBURETOR
| Type | thread | tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | Carburetor to intake manifold | M10/M20/M30 | 10 Nm | ||
| 2AZ | Carburetor to insulating flange | M10/M20/M30 | 10 Nm | ||
| 3AZ | Insulating flange to intake manifold | M10/M20/M30 | 10 Nm | ||
| 4AZ | Idling shut off valve; max. | M10/M20/M30 | 5 Nm | ||
| 5AZ | Flow valve; max. | M10/M20/M30 | 28 Nm | ||
| 6AZ | Throttle valve assembly to float housing; max. | M10/M20/M30 | 9 Nm | ||
| 8AZ | Throttle valve control to carburetor; max. | 2BE | 3 Nm | ||
| 9AZ | Warm-up regulator to engine | M10/M20/M30 | 23 Nm | ||