61 61 100 Removing and installing/replacing both windshield wiper arms

WARNING: This page is about a different car, the 2003 BMW Z8, 2002 BMW Z8, 2001 BMW Z8, and 2000 BMW Z8. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

61 6 060

Remove cover (1).

Fig 1: Removing Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nut (1).

Fig 2: Removing Nut

Courtesy of BMW OF NORTH AMERICA, INC.

CAUTION: Do not bend wiper arm during removal (risk of breakage).

Pull off wiper arm (1) with special tool 61 6 060.

Replacement:

Remove wiper blades.

Fig 3: Removing Wiper Blades

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Adjust position of wiper arm in rest position (measured between wiper lip and top edge of cowl cover).

Fig 4: Identifying Adjusting Position Of Wiper Arm

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten nut of wiper arm to appropriate torque, 61 61 9AZ. Refer to BODY EQUIPMENT - TIGHTENING TORQUES .

After waiting 15 minutes, tighten nut again to appropriate torque, 61 61 9AZ.

Check position of wiper arm again, repeat adjustment procedure if necessary.

Installation:

Check/adjust contact angle of wiper arms to windshield.