Removing shift sensor

WARNING: This page is about a different car, the 2010 BMW 650i, 2009 BMW 650i, 2008 BMW 650i, 2007 BMW 650i, and 2006 BMW 650i. However, it is still accessible from the selected car via links, so may be relevant.

Unfasten screws.

Tightening torque 23 41 11AZ .

Turn shift sensor (1) approx. 90° clockwise.

Installation:

Replace screws.

Fig 1: Turning Shift Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out shift sensor (1) upwards at an angle.

Unclip cable.

Fig 2: Removing Shift Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fit shift sensor (1) downwards at an angle and turn counterclockwise until installation position is reached.

IMPORTANT: Risk of damage:
When fitting shift sensor (1), make sure that lever (2) engages in groove (3) on selector rod.

Fig 3: Turning Shift Sensor

Courtesy of BMW OF NORTH AMERICA, INC.