11 41 Oil Pump with Strainer and Drive
WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - OIL PUMP WITH STRAINER AND DRIVE
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Intake pipe to bedplate | N54 | M6x30 | Replace screws Thread repairs exclusively with Al Helicoil. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | |||
| Torque angle | 100 ° | |||
| 2AZ Oil pump to bedplate | N54 | M8x123 | Replace screws Thread repairs exclusively with Al Helicoil. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 10 Nm | |||
| Torque angle | 180 ° | |||
| N54 | M8x31 | Replace screws Thread repairs exclusively with Al Helicoil. Jointing torque and angle of rotation must be observed without fail. |
||
| Jointing torque | 10 Nm | |||
| Torque angle | 90 ° | |||
| 3AZ Chain module to crankcase and oil pump | N54 | M6x16 | Replace screws Thread repairs exclusively with Al Helicoil. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | |||
| Torque angle | 45 ° | |||
| 4AZ Sprocket to oil pump | N54 | M8 | Jointing torque | 20 Nm |
| Torque angle | 45 ° |